- #OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE INSTALL#
- #OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE DRIVERS#
- #OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE UPDATE#
- #OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE FOR WINDOWS 10#
#OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE INSTALL#
If whea_uncorrectable_error started after install new hardware or application, driver update, while playing a game, there is a chance the recent changes could be causing the error.
#OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE UPDATE#
#OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE DRIVERS#
Corrupt or outdated device drivers can also lead to WHEA_UNCORRECTABLE_ERROR Thus, check your drivers to solve this problem.
#OVERCLOCK IN BIOS OR ALIENWARE SOFTWARE FOR WINDOWS 10#
Check for Corrupted or Incompatible DriversĪnother common reason for windows 10 blue screen error are the device drivers. This option is usually in either the Security tab, the Boot tab, or the Authentication tab.If still the present, check out the next solutions. Find the Secure Boot setting, and if possible, set it to Disabled.Go to Troubleshoot > Advanced Options: UEFI Firmware Settings. Or, from Windows, hold the Shift key while selecting Restart. You can often access this menu by pressing a key during the bootup sequence, such as F1, F2, F12, or Esc. To check for updates, go to Windows Update, or check your manufacturer's website. From time to time, your manufacturer may update the list of trusted hardware, drivers, and operating systems for your PC. Before disabling Secure Boot, consider whether it is necessary.
I would also suggest you put the SSD on the same Cable Connector as where the HDD was connected You can then reclone the HDD to the SSD and put it back into the computer. I would suggest you take out the SSD and then Disable Secure Boot as described below. Plus we'd have to hunt down all the drivers and whatnot too. We're doing the cloning method because we don't have the Windows key (no sticker on rig) or any discs, despite it being genuine. I must leave it in UEFI for a successful boot.
But like I said, switching to Legacy is the only way I can adjust boot order, but then it will not boot off either drive. "Internal Hard Disk Drive not found" error. I have tried disconnecting the HDD, but it will not boot at all. I have to leave it on UEFI and then it will boot into Windows properly (off the HDD still connected). And if I change it to legacy, neither of the two drives will boot into Windows. However, I cannot change the boot sequence while under UEFI (default). The plan was now to just switch the boot order, wipe the HDD and use it for storage. We added a 500G SSD, initialized it as a storage drive and it showed up under My Computer, cleared the Alienware HDD down to under 500GB, used EaseUS Todo to clone the HDD onto the new SSD.